3fingerpat

view all » Latest Blogs

Shaker End Table #13: The Last Picture Show

I got mixed results using the table saw to level out the leg on the table. I had some splintering on the edges and took a little to much off on the first pass causing tilting on the other leg. So I used a sharp chisel to shave off the necessary...

Shaker End Table #12: Not much left but the wiping

After test fitting the drawer with the one side on, I realized that I had left the sides long. Long enough that I was able to cut off the end of the board that I had screwed up in the previous post. So no new wood was needed, I got busy cutting...

Shaker End Table #11: Oh yes I did...

I planed down both side pieces to provide a snug fit in the drawer opening. I used a marking gauge set at 1/2" to scribe my gauge line on the side and face pieces. I used 1:6 Dovetail marker and laid out 4 tails with spacing that looked even...

Follow

0 Comments