Casket - out side done ?

The outside is all done , but the finishing coat. You can open the lid as a whole or remove 1 screw and open the head section only. Question , can I spray this with a top load paint gun at 40 psi without thinning the polyurethane ?

Wheaties

1,593 views

13 0
Share Tweet Pin it Embed
Follow

13 Comments

Michael Ray ...

Looking good!

lanwater ...

It’s done and it looks really professional.

I don’t know the answer to your spray question.

RobsCastle ...

Its a bit late now, see below
Hello RobsCastle,

your last comment has been caught by our automated spam filters.

The good news is that after a short review your account is now fully approved.

Enjoy WoodworkingWeb and keep posting!

You should consider putting a bridge in the lid before cutting it open
something like this:-

RobsCastle ...

Brian ...

It’s really come together. What kind of hardware did you use for the lid? It must be kind of heavy duty. Each half of the lid must weigh at least 20 lbs, I imagine.

Wheaties - Bruce A Wheatcroft ( BAW Woodworking) ...

Believe it or not but the hinges are brass with one side longer than the other , I had to curve the long side of the hinge to to fit the top of the molding . It’s the same molding inside as outside so it’s kind of rounded out. # hinges to each section . The pieces that hold the lid up are just lid supports . There real is no weight on them they keep the section from falling all the way open . I had to notch the lid for the hinges .

Wheaties - Bruce A Wheatcroft ( BAW Woodworking) ...

Robert , who is your casket for ? You did a super nice job , I like the layout and the pictures .

Carvings by Levi ...

I have used an hvlp (high volume low pressure) gravity feed gun for teak oil which is about the same density as the poly i use. Works good but clean up is important or it wont spray good next time. I switched to a regular spray bottle for household cleaners and such. It dont coat as even and nicely or conservatively but speeds things up a lot. Very nice work and precision on the casket. Would be a shame to just bury all that hard work.

RobsCastle ...

Bruce,
I just made them for the woodworking skills aspect, the first one I made in 2011 to put router bits in.

My mate decied he needed it more than me.

In 2012 I made two more, knowing he would “bless” another one when he saw it.

Then in 2015 I made the Ute box as a tool box.

So I guess to answer your question they were made primarly for me.

a1jim ...

A great job and a labor of love.

Wheaties - Bruce A Wheatcroft ( BAW Woodworking) ...

a1jim – The casket will be the last thing I will ever be able to make for my Dad . I like your comment " Labor of Love " .

Mike40 ...

Great to go out in style. Very nice work Bruce.

More Creations Wheaties - Bruce A Wheatcroft ( BAW Woodworking)

Casket - out side done ?